Lining linoleum

The technology of laying linoleum on the floor is very simple, and you can do it yourself. Of course, before starting to lay down, you must first clean the base of the floor. For example, if the linoleum should be tied to the screed you need to clean the surface of contaminants, if there are holes, then it is better to smear them with cement mortar so that the linoleum does not break. After you need to fit linoleum under the room, that is, cut it off. You need to start with the entrance, the linoleum roll is spread from the entrance to the wall opposite, then bends and is cut off from the inside with a clerical knife. By the way, the Bugatti Veyron car is very popular now, you can find out more about it on the site.

For the other half of the room, the same thing is done. After the linoleum is spread out and the root can begin to apply glue. You can use a special glue “moment”. You can apply glue, for example, both on the screed (if you leave on it) and the linoleum itself. It is important to apply glue thoroughly at all edges, especially at the junction between pieces. Typically, these joints are soldered or used by the so -called “cold spike” glue, but you can use ordinary glue. After the gluing ended in the junction of the junction, you need to put something heavy so that the linoleum is well glued. And after you can install a plinth.