The technology of plastering walls

Purvation of walls occurs in several stages. Stages include the application of several layers. The work begins with the surface spraying. If the plaster is applied to the concrete or brick wall, then ideally the first layer should fluctuate from 3 to 5 mm. When plastering wooden surfaces, spraying should be applied in a layer of about 9 mm. Now the production of metal structures is very popular, they are very often used in construction work. Go to the site — for more information about metal structures.

Before starting the process, the surface must be moistened with water so that all layers are as fixed as possible to each other. However, the first layer, which was applied by spraying, will not be able to eliminate all the shortcomings and flaws of the surface, so there is a need to use a primer.

A primer is applied to the first layer of plaster. Its consistency should be tested. The primer will smooth out all the irregularities and eliminate defects on the surface. If the plaster was applied with a fairly thick layer, then the primer must be applied with several layers, otherwise it can slide.

At the last stage, a layer of plaster is applied to the primer, which should not exceed 4 mm. This stage of work is aimed, first of all, at the complete leveling of the primed surface. It should be borne in mind that the thickness of the last layer of plaster will directly depend on the quality of the soil of the soil and its flat surface.